Copper & PEX Repipes · ZIP 91501–91506
Whole-House Repiping in Burbank, CA
Rusty morning water, a shower that dies when the washer fills, another pinhole leak in the wall — that's 70-year-old galvanized pipe talking. We replace it all, patch the walls, and hand you back a house that flows like new.
Why So Many Burbank Homes Need a Repipe
Burbank grew up fast after the war. The bungalows of Magnolia Park, the ranch homes of the Rancho Equestrian District, and the tracts across McNeil, Chandler Park, and Toluca Woods mostly went up between the 1940s and the 1960s — and nearly all of them were plumbed with galvanized steel. Galvanized pipe was rated for roughly 40 to 60 years of service. Do the math: the original supply lines in these homes are now decades past their design life, corroded from the inside out, and shedding rust into your water.
When homeowners search for a repipe in Burbank, it's usually after years of managing symptoms — a pressure-boosting shower head here, a patched leak there. A whole-house repipe ends the cycle. Every hot and cold supply line from the meter to the last fixture is replaced with new copper or PEX, sized and routed to current California Plumbing Code.
Signs Your Burbank Home Is Ready to Repipe
- Low pressure at every fixture — not one bad faucet, the whole house
- Rusty or brown water first thing in the morning or after a vacation
- Repeat leaks — a second or third pinhole in the slab or walls within a few years
- Scalding swings when a toilet flushes or the sprinklers kick on
- Crusty white-and-rust buildup on visible fittings in the garage or under sinks
Two or more of these usually means the pipe is failing system-wide, and spot repairs are money spent postponing the inevitable. Our guide to the signs your galvanized pipes need replacing goes deeper on each symptom.
Copper vs. PEX for a Burbank Repipe
| Copper (Type L) | PEX-A | |
|---|---|---|
| Service life | 50+ years, time-proven | 50-year expected life, 25-year manufacturer warranties common |
| Cost | Higher — material and labor | Typically 25–40% less than copper |
| Seismic behavior | Rigid; joints take the stress | Flexes with ground movement — fewer joints in walls |
| Hard water | Can scale and pit over decades | Highly resistant to scale and mineral corrosion |
| Wall openings | More cuts to route rigid pipe | Fewer, smaller openings — less patching |
One local consideration worth naming: Burbank sits close to the Verdugo fault, and in an earthquake, flexible PEX with continuous runs and minimal in-wall joints has a real advantage over rigid soldered pipe. Plenty of homeowners still choose copper for its track record — both are excellent when installed correctly, and we quote both so the decision is yours. The full comparison lives in our copper vs. PEX repiping guide.
How a Repipe Works — Start to Finish
Fixture-Count Flat Quote
We walk the house, count fixtures, and give you a flat price for copper and for PEX — free, in writing, no obligation.
Repipe in 2–3 Days
New lines go in with water restored every evening. Floors covered, furniture masked, home livable throughout.
City Inspection
We pull the Burbank permit and walk the inspector through the open walls before anything is closed up.
Patching Included
Drywall openings are patched to paint-ready condition as part of the quoted price — not a surprise line item.
Want the long version — pipe routing, insulation, valve and hose-bib replacement, what happens to the old pipe? It's all on our main whole-house repiping page.
Burbank's Hard Water Makes It Worse
Water from Burbank Water and Power runs hard, like most of the San Fernando Valley's blended groundwater supply. Inside galvanized pipe, that mineral load accelerates the corrosion scale that chokes off flow — the two problems feed each other. It's part of why galvanized systems here often fail sooner than the textbooks predict, and why new PEX or copper paired with sensible fixture maintenance holds up so much better. More on that in our hard water guide.
What a Whole-House Repipe Costs in Burbank
As a typical range for the LA area, a PEX repipe of a two-bathroom Burbank home generally lands somewhere in the $9,000–$16,000 neighborhood, with copper running roughly $14,000–$25,000 depending on fixture count, crawl-space access, and finish patching. These are typical ranges, not quotes — your price is a written flat number you approve before work begins, and it doesn't move. Financing options are available, and the free estimate costs you nothing but an hour.